Gypsum panzer (C1T)

Gypsum panzer (C1T)

Cementitious tile adhesive, specially indicated for gypsum substrates

What is this product?


It's a white mortar-glue, for medium-high absortion ceramics walls, for interiors and thin coat, over surfaces with gypsum presence such as:


Gypsum board panels.

Gypsum covered walls.

Big format brick walls.

Gypsum-covered brick walls.



Monocomponent mortar-glue.

No vertical slip.

Thin coat application for interiors.

Containing retainers that prevent that forging needed water is absorbed by the wall.

How to prepare?


1- Pour the water first and then, the mortar-glue.

2- Mix in bowls in an approximated proportion of 7,5 litres each 25 kgs.

3- It is very important to not add more water than recommended, because physical and chemical conditions would be then, reduced. 4- Mix by hand or with a mixer machine (better slow, 500 rpm) until getting a creamy paste.

5- Let it repose 5 minutes for the additives to act correctly and then mix again before use.

6- Never add more water after the paste settles.

How to use?


Substrate must be clean and dry.

Extend the product with the smooth part of the trowel to ensure a full contact with the wall.

Apply the dented trowel (no. 6-8) in 1,5-2 m2 squares.

Check that no surfacial film is formed over the adhesive. In such a case, it's enough to pass the trowel again with some fresh product.

Place the ceramic leaving 2-3 mm joints.

We recommend to leave 3 mm expansion joints in the extremes of the walls.

Where to use?


Ceramic materials placing, for interiors. Using substrates: Traditional gypsum covered walls, plaster, boards, gypsum boards, big format bricks and gypsum covered bricks.

Do not use: On metal, fibercement, wood, tiles and old tiles.

In these cases, mix with ADESILATEX 1000.

Technical data: Gypsum panzer (C1T)




Coat thickness in walls

Output in walls

Mix water

Open time according to UNE EN 1346

Rectification time

Initial adherence according to UNE EN 1348

Adherence after water immersion according to UNE EN 1348

Adherence after frost cycle according to UNE EN 1348

Fire Reaction

Waiting time for rejointment

Wall vertical slip according to UNE EN 1308

Temperature during application

Paste density

Stockage (from manufacturing date, under cover, in a dry place)



White Powder

25 kgs bag

from 5 to 8 mm

from 3,5 to 4 kgs/m2

7,5 litres each 25 kgs

20 minutes

10 minutes

1,6 N/mm2

0,9 N/mm2

0,7 N/mm2


4 - 6 hours

< 0,5 mm

min 5ºC, max 32ºC

1,6 gr/cm3

12 months



White cement.

Siliceous soils.

Additives and resins.



Product components are not toxic.

It must be worked with gloves, avoid powder inhalation and contact with eyes and skin.

Keep away from children or animals.

First Aid


Skin: Wash with plenty of water.

Eyes: Wash with plenty of water.

Ingestion: Rinse with water and drink plenty of water.

This technical data is written according to our knowledge and essays and doesn't assume any commitment. It's on customer's responsibility the admission and control in the distributor's warehouse or construction, as well as the election of the product to be used on each case. Manufacturer's responsibility is limited to manufacturation defects and for the value of the merchandise because it's out of his control the material election and the working conditions. Technical data for 2009.